Glade Sense & Spray Air Freshener, Motion Activated Automatic Odour Eliminator for Home, Clean Linen, Starter Kit with Holder & 18 ml Refill

Product Information

It growls every time I walk past" ;o) I have the clean linen scent which is very appropriate for this room. This means that the current itself would be proportional to light input through a range – notable exception is no light, where a small leakage occurs, known as dark current, and very bright, when the transistor is fully on and driven into saturation. Unfortunately, there’s not much in there that will give hobbyists something to salvage, but it was interesting to see how simple it is given the fact it uses a dosed canister (thus, the timing of the nozzle up/down is not as important) and the use of limit stops to limit the travel (thus, no positional feedback is required).

You could use them to take measurements, or even as places to solder on wires if you wish to abuse them in that sense.The exterior of the unit is brown, with speckles, a sort of poor wood imitation that reminds me of tupperware. Choosing the right motion activated air freshener dispenser involves considering the size of the area and the desired intensity of the fragrance. It might have a fixed threshold detection, as under artificial lighting, it doesn’t reliably trigger, although it would be possible to make it more sophisticated (e. Stopping here, you end up with a can of air freshener, 3 batteries, 2 slide and 1 push button switches, a cool aerosol valve, a medium power PNP transistor, a two wire connector with leads, and a LED. Not sure I like the smell, its really strong, and its quite annoying to get a full burst of spray when you walk past.

My only concern is that its not at all environmentally friendly so I will be thinking carefully about whether to carry on getting the refills. But does the current between collector and emitter also fluctuate, or does it suddenly come on at a set level when a threshold is reached in the amount of base current? You should also see 100k between the base and the emitter of the transistor (make sure to put the positive lead on the emitter). I grabbed one off the shelf today for the same reason, to see if there were a couple parts to play with with the arduino, then found your article.do you think if there a way to re-program or hack this device so it does not do the automatic spraying which it does every 30 minutes which is too much waste of scent and makes too heavy to bread the environment. With a improved air freshener option, many can have a moisture-wicking ability, reduce theacteria, and bacteria, and infections. The battery-operated holder conserves refills using motion sensor technology, motion activated releasing a burst of home fragrance when you pass by or turn on the light. As far as I can tell, it’s a fixed function device, so there isn’t really any way to reprogram it as such. The unit itself has the front panel push button for an immediate spray (termed boost), with a translucent white plastic for the LED to shine through, and a hole for the sensor.