BAOFENG GT-3TP Mark-III 8W/4W/1W High Power Dual Band Two-Way Radio Transceiver 2 Pack + 2 Remote Speaker + 2 Car Charger + 1 Programming Cable Orange

Product Information

Also, please perform a search through all open and closed issues. Maybe someone else had the same problem before, and a solution is already available. success_moderated": "Your comment was posted successfully. We will publish it in a little while, as our blog is moderated.", While the instruction manual isn’t great, it does provide enough information to get your radio set up and running with the basic functionalities. Be warned that anyone who is starting out with ham radios will face a steep learning curve.

Baofeng GT-3 Radio successfully programmed with Chirp Baofeng GT-3 Radio successfully programmed with Chirp

FM Receiver Chip: The RDA5802N has a powerful low-IF digital audio processor. This makes it have optimum sound quality with varying reception conditions. If your problem is about how to use CHIRP with an already supported radio, then you should ask that question in the mailing list. Antenna Interface: Fine copper antenna connector outperforms previous antenna connectors and improves communications. Big buttons & knob: GT-3TP has built in PTT key, CALL key, and MONI key on the left side of the radio As for use, the radio has a terrible front end and received interference like crazy. I had the local NOAA station as Channel 0 and the local Skywarn repeater (146.880) set as Channel 1. It wasn’t uncommon for me to receive on both Channel 0 and 1 at the same time, even though only one was selected and the second VFO was set to Channel 3. This would be a terrible radio for fox hunting or radio direction finding. If this is your main use, I would pass.The car charger is actually 10 volts rather than the typical 12 volts. The charging cradle of the GT-3TP is specifically designed to take a maximum of 10 volts. It’s actually a nice gesture on behalf of Baofeng to keep the parts consistent. The annoying bit is that you still need to connect the car charger to the charging cradle rather than directly into the radio for car charging.

Download - Baofeng

Note: Factory defaults frequency is 140-150/430-440MHz (8W Output), please reset the radio to reach 136-174/400-470MHz or program it to reach 470-520MHz (The software is the same as GT-3 Mark-II).Power Amplifier IC: Low crossover distortion, Low quiescent circuit current. Provides plenty of clean, clear receive audio.

Baofeng GT-3TP Mark III 8W Dual Band Radio

Big buttons & knob: GT-3TP has a built-in PTT key, CALL key, and MONI key on the left side of the radio Special Optimization: Optimized SQL settings and modulation of TX/RX power tubes to improve the quality and stability of the transmission. There are also 50 CTCSS/104 DCS to provide group calling convenience and reduce external interference.no_content": "This section doesn’t currently include any content. Add content to this section using the sidebar." Upgraded Antenna: The 21cm high gain antenna has better stability and performance compared to the old antenna. Combined with 8W high output power, the dual band two-way radio can even extend the talking range up to 11km. New antenna: custom high gain Sainsonic INF-641, ultra flexible, better performance, longer range Spesifikasi Baofeng GT-3TP Mark III Frequency Range