True Latch 6' Telescopic Gate Brace - Wood Privacy Fence Anti Sag Gate Kit - Gate Hardware Kit for Outdoor Wooden Fence Gates, 1 PATENTED USA made brace (6' Telescopic (40" - 74"), Black)

Product Information

One of the most common causes of gate sag is when the posts begin to rot, weaken or settle, no longer providing accurate structural support for the gate. If the gate hinges become loose or dislodged, or the latch is not adjusted properly, this further increases the probability of gate sag. Now line up the glued spars with the pencil marks, also ensuring the spar ends are lined up with the tongue and groove edge. To ensure you place your other gate post in the right position, then we used something with a straight edge along the floor. This needs to be the same width as the gate gap. Other types of gates, like farm gates, might have other types of bracing, including W-style gate bracing and simple vertical braces, depending on the design and style of the gate. Can You Retrofit a Gate with Anti Sag Bracing?

We placed ours on the front section facing the garden as there's already another gate on the other end of the walkway. Adding a Bolt On a Wooden GateSometimes integrated adjustable hinges will eliminate or off-set sagging when gates are in a closed position but do not offer a solution when the gate is in a fully open position. In my opinion, any gate over 16' wide that swings needs a suspension brace with some form of adjustment, like a truss rod. Because Horizontal Bracing alone is often NOT enough on wide spans. I believe that a combination of bracing techniques works best, especially with wooden frame gates. When you see a gate that has implemented two designs, say compression brace with a suspension cable that can be attenuated or a compression brace with a strut, then you get the best of all support means without twisting or causing gate frame to warp. So if you're building anything heavier or wider, then I recommend making one. You can watch me make a Z frame brace here. An important gate brace rule:

Calculate the length of the hypotenuse by finding the sum of the squares of the lengths of the two legs of the triangle and then taking the square root of the sum. If you’re building larger gates and you plan to have built-in anti-sag bracing, there are several options you could consider, such as:The gate is 6ft high and is faced by feather edged fence slats. These are also available readily from timber and builder merchants. You can see more about feather edged timber here. Feather edged timber usually comes in lengths of 5ft, 6ft and 8ft and can obviously be sawn down so any size gate is possible. DIY Garden Gate Making Instructions Then added another screw to each end tongue and groove section and one on each board in between. Note, these should be screwed only where a spar is behind.