Malachite SDR Radio Malahit DSP SDR Transceiver Receiver with Touching LCD Screen 50k-2GHZ Black Universal Tool for Home

Product Information

These upgrades show again that the Malahit team is serious about improving the current DSP-2 model, though it’s clear development continues for new hardware that will likely be available in coming months. If your new review has not been Approved after several days you can assume that it was found to not be within the product review T's&C's shown below during screening. Additionally, even if something has an Open Source license, this may not always grant rights to use commercially, i.e. someone using the source code and design files to have units manufactured, which they then sell on. Its a shame these radios are so so widely and for so much to non specialists, as they represent very poor value for money unless you have the skill and time to upgrade them I can’t read Russian, but with the help of Google Translator, we can find some interesting details:

As to updating firmware – after navigating the YouTube videos and Russian language instructions provided by Malahiteam, using the STM32Cube software has, for me anyway, become fairly routine. One could easily argue that the numerous signal processing and other flexibilities of the Malahit make that decision for you. While the Belka DX is superior in many respects, it lags behind the Malahit on sheer number of settings, though the Belka’s fixed processing positions are more than sufficient for superb reception on shortwave. Do not submit a product review critiquing another review or reviewer. Reviewers should be able to share their product opinion without being publicly criticized. This video shows a comparison between the DSP-2 and Afedri LAN-IQ Standalone receiver. Both units were placed in roughly the same receiving location, with the Afedri using a BNC-connected whip. The DSP-2 was using a somewhat shorter whip along with a 50 ohm impedance module, with the HI-Z setting on the DSP-2 set to OFF. As I said, this is more noticeable than before, especially when not using the PRE-AMP feature. With PRE-AMP engaged, signals are more audible when the receiver is left on its own. With PRE-AMP off, for example when listening to the usually strong signal on 12,160 kHz, programming can barely be heard.

Finance Available

It is powered by an external TYPE-C (for Huawei mobile phone) interface or battery (built-in 3000mah lithium battery), which can be charged by TYPE-C, The frequency range is different. This is the difference to specific design solutions. And the DDC has to catch up with the DSP version due to the additional board developed with converters. The additional board is already under development. A valid product review is one where you have experience or knowledge of the product that you would like to share with others.

I read about them for a while before taking the plunge, and certainly some Chinese clones are reported as being not up to scratch, however mine (badged 'Jstvro' on the front) appears to have no problems at all. Important to make sure its firmware is legitimate (registered). But I had to offer up this comparison. Even with noise reduction efforts on the part of Malahit Team, in the end, you’re not likely to hear much more using a Malahit that you won’t hear also on a Tecsun 501x or similar recent portable – IF you’re a skilled operator with thorough knowledge of the bands. The result: indeed the numerous noise spikes that are seen so prominently when using the receiver with a whip antenna, indoors or out, seem to disappear or become subsumed in the noise floor of the receiver.I have deliberately not connected my Malahit DSP-2 receiver to my central antenna system which uses Wellbrook and W6LVP loops feeding numerous receivers through a multi-port that maintains constant gain.