Joined in 2023 
82 
63 About this deal
You can turn on or off the parent unit screen without powering off the parent unit. You can still hear sound from the baby unit.
Press the pair button several times (normally about 5 times) until you hear a beep tone. The camera will start resetting. For hearing protection, make sure the parent unit is more than 3 metres away from the baby unit. If you hear any high-pitched noise from the parent unit, move the parent unit further until the noise stops. You can also press - VOL on the parent unit to lower or mute the noise. With Direct WiFi Mode on the VTech RM5764, the monitor is ready to use out of the box for local monitoring between parent unit and camera.Camera lens and surface may get warm during normal operation. Charge the parent unit battery before use You may experience reduced signal strength if your parent unit and baby unit are far apart, or there are obstructing factors, such as internal walls, between them. Move the parent unit closer to the baby unit to improve the signal strength. You can also set up Router mode to connect via your home Wi-Fi network to improve the connection between your parent unit and baby unit. Avoid putting it near heating appliances and devices that generate electrical noise (for example, motors or fluorescent lamps). To ensure that your HD video monitor is always at its best performance, the parent unit will prompt a message and ask you to update its software and the baby unit's firmware when there are new versions available. The parent unit and the baby unit of your video monitor connect to each others in Direct mode by default, which allows you to stream live video right out of the box. Direct mode connection lets you stream live video from parent unit only.
Can pair, view and control up to 2 cameras on the parent unit & the VTech app (RM724 sold separately). Multi-cam viewing modes are single cam, split screen or patrol mode. When both parent unit and app are viewing the camera simultaneously, the video quality will be optimised to deliver the best possible viewing result. Make sure the parent unit and the baby unit are not connected to the switch controlled electric outlets. If you drill the holes into an object other than a stud, insert the wall anchors into the holes. Tap gently on the ends with a hammer until the wall anchors are flush with the wallWhile viewing image from the baby unit, press to pan the baby unit leftward, upward, rightward or downward. IMPORTANT NOTE: PERFORMANCE OF YOUR BABY MONITOR IS DEPENDENT UPON THE RELIABILITY OF THE DIRECT WiFi OR ROUTER MODE CONNECTION STRENGTH IN THE HOME Off when the parent unit is disconnected from AC power, or when the parent unit is connected to AC power and the battery is fully-charged. You can monitor the baby rooms temperature with alerts to your phone. You can even set up motion detection alerts and recording! The sound activation lets you know when baby wakes and is making sound.
Launch the camera app or QR code scanner app on your smartphone or tablet. Hold the device's camera up to the QR code and frame it. Tap the notification to trigger the redirection of the online help.Follow the instructions in the mobile app to pair the camera. Tap + in the mobile app to get started. With Router Mode, the parent unit and camera are paired to operate via the WiFi router, this also allows Increase the parent unit speaker volume if you cannot hear the sounds transmitted from the baby unit. Insert the screws into the holes and tighten the screws until only 1/4 inch of the screws are exposed. You can use your smart phone or tablet device for Remote viewing and recording via the free VTech app.. That means both record images and video to your smartphone or tablet memory using the app! And it’s a free app! VTech RM5764HD Key Features:
Great Deal 
New Comment